Questions   Motor drives


About the Motor drives category (2)
Enable VSD-E problem / Dual (11)
Setup granity for 34 nema hybrid stepper motor (1)
Argon and custom firmware (3)
Bosch absolute encoder compatiblity? (7)
Manually setting 'home' position on Argon (1)
Granity Firmware revision ID error (3)
Enabling digital outputs on Argon from Granity? (5)
Argon undervoltage, no phasing and init (12)
New Mige BISS-C Encoder ( 2 3 4 5 6 7 ) (121)
Ioni drives - Lower gain when at standstill (1)
Limit Switch output IoniCube (6)
Using IONI to feed an servo motor driver with +- 10V (4)
Argon Enable in signal (6)
VSD-E, Dual DC. Resolution issue (5)
Limited PI gain resolution (4)
Incremental Eltra Encoder connection scheme (3)
Lower Connector screws IONICUBE X7 X9 (3)
Argon Drives as replacement for Allen-Bradley Drives (2)
Argon Linear Servo Encoder Setup (6)
I want to run Argon and VSD-Ex 160 from ethernet smooth stepper (3)
E-stop safety PL, SIL categories (2)
Wheel out of center position when in Assetto corsa after upgrading to IONI 1.7.4 firmware (15)
Kollmorgen AMK54G vs 54K (14)
BLDC Motor jerks if not "gently" moved first time after power up (2)
Mige Motor shielded cable (4)
Random servo motor behavior (3)
Hissing noise from motor (16)
Suitability for Linear motor Gantry OpenPNP project (6)
Notch/hitch/jolt around centre AKM motor (5)