Yes, it has worked great.
I am working on device setup on it.
Anyone have a device setup configuration for an Augury with 10000 points encoder?
I think this will work Follow the problems Small MiGE 10k test2.drc . Have you updated your ioni firmware?
No didn’t update IONI firmware because i believed your .dfu have the both.
Wouldn’t hurt to check just to be sure.
Don’t forget to also setup mmos with settings , pwm & dir , 3.4Khz and 40000cpr
How could i know the firmware of my ioni?
I tried with this setting but my motor doesn’t have any rotation lock, and seems like strange comportement like some vibrations.
How did you load the drc? with the same program granity you can check the version of your ioni
It could be your mmos settings but you could also try another drc given here by mica
What do you mean by drc?
I cannot acces to Simucube Sotfware to check my configuration because everything is grey and disabled.
Should i download the granity software to check something?
You have to use latest granity (also you have to connect the 2nd usb to your computer) connect to see what ioni firmware you are currently using and also load the drc file if your motor settings are lost. You could either load mine or the one from mika to check.
If the motor parameters aren’t lost take pictures of all the tabs or save them as drc for reference.
Aha, you are using a very old 1108 version of IONI firmware. There is a big red warning / things to do before upgrading to Simucube firmware. Installation of 1.6.1 (10601) or later is required before attempting Simucube firmware install.
Ok i Updated the ioni on 1.7.10.
Should i do something else?
Did you keep photos of your motor settings (the other tabs inside granity ? ). I am asking because if you are not careful when updating ioni firmware you can wipe motor settings.
Anyway , just enter inside granity and give us photos of all tabs to be sure.
You can either fix the thing you have with mmos or now that you updated ioni you can try to upgrade to simucube again.
Some screenshot about my motor settings after new firmware on IONI.
I tried directly to upgrade the firmware on Simucube and unfortunely without success.
I tried the both .dfu.
Nothing happen after i open this Simucube software.
I don’t know why really …
the part about the update to simucube firmware is on the hands of the dev.
Before you do anything , just to be clear , your motor is 130st-m10010 (small mige) or 130st-m15015 (large mige) ? With the settings i see you must have the large.
Also post photos from tuning and faults tab just to be sure.
As for your settings hit Measure resistance and inductance , let it do it’s thing and after it changes MR and ML values automatically hit apply. Also check that TBW at tuning tab is at 680 and Foc at faults tab is at max. Exit and save.
After that retest mmos. If you still have problems post photos of your mmos settings.
Ok your settings are ok in terms of granity. Just test mmos and if something doesn’t feel right it is something with mmos settings. Then post mmos pictures to help you out.
I have problem with my SRC-GT1 (Wheel with button made by augury).
No one buttons work.
See below my configuration on MMOS.
I would turn off min force and those effect filters for starters.
Your button plate connects to simucube?
OK its done for the Min force.
How do you know if yes or not button plate is connected by software?
I only know the configuration USB device and see the button doesnt work.
The buttonbox has a seperate usb that connects straight to your computer?