SimuCube 1 no analog X11 signal, while buttons and X12 work fine

Simucube 1
1

Hello,

I connected two buttons via X12. These work perfectly, both upper and lower. However, I cant get the X11 ports to work. I am trying to connect a DIY handbrake which has a potentiometer. I followed the wiring guide, but it does not work. I checked with a multimeter all the pins on both X11 ports but I cant get a signal through any of them. Is there a step I am missing, to enable analog signals, or what should I check?

2

Can you show how they are wired up right now?

3

I followed this:
https://granitedevices.com/wiki/SimuCUBE_pinouts_and_wiring

Your answer here:

and

EDIT:
1 for ground
2 for signal
3 for power

and I tried switching 2 and 3.

IMG_20201004_193323
IMG_20201004_1933234608×2176 2.72 MB
IMG_20201004_193352
IMG_20201004_1933524608×2176 2.1 MB
IMG_20201004_193428
IMG_20201004_1934284608×2176 2.72 MB

4

Update:

I wired the potentiometer up with a Leo Bodnar BU0836A joystick controller and it works. So I think for some reason my simucube analog ports dont work.

5

Did you select the analog input to be used and checked its indicator in the Configure Analog Inputs screen?