thanks a lot for your help,
I no longer have the steering wheel next to the pc (I took it off for Christmas),
but what I can tell you is that:
-to switch to true drive, I can’t do anything because the software is not detected by the steering wheel,
however, as soon as I turn on the engine, the fan runs at full speed, and the box becomes very very hot really quickly
What part of the box gets hot? PSU, or? Please check next after Christmas is over. Sounds like something is kaput.
thank you so much,
the part that heats up is really the part of the box under the simucube board
Sounds like something is shorted or that the voltage output of the PSU is so high, that the IONI will constantly try to burn it as energy in the braking resistors, so the PSU is working overtime all the time.
But that does not directly explain why the whole system is not visible at all on the PC.
if you are good with hardware , why don’t you try to assemble this outside the box
Hi all
and sorry for my late replies,
I had a lot of things to sort out and I dropped the project.I’ve pulled myself back into the game,I changed the diet she was screwed,
And now the material is recognized by computer and by granite devices,the ioni is lit green,When starting the steering wheel, turn three or four quarters left and right and return to the center,
but it is not recognized in play,
and the MMOS software does not act on the steering wheel,
Do you know what to put in the Granite Device part for this type of steering wheel with an Ioni Pro?
Can you post your granity settings and your mmos settings please
thank you for your reply
I also give you the MMOS settings, but MMOS does not affect the behavior of the steering wheel
you left out the Fault Limits tab settings.
sorry I hadn’t seen
Please also show the device setup from mmos
Sorry
I have a suspicion that it is related to your encoder. I would also change some other parameters but i doubt it would make a difference regarding your problem. First of all the ioni firmware you have is not intended for use with simucube but i can not tell if that’s a problem since you don’t have a biss encoder so wait for a developer on this. If you don’t want to wait try the previous version 1.7.20 , but first thing to try is: Cpr is 4 times the ppr value. So set it accordingly in the mmos setup.
Thanks you very much i will try that, and i will keep you informed !
I changed the firmware version for the Ioni, I even tried 1.7.20
I no longer have to register
the gaming device appears well in content manager for example (even before all these manipulations it was displayed)
but when I turn the wheel nothing moves, not even in USB gaming devices
inside granity , in the testing tab, when you move the wheel does it change any value ?
yes yes it changes the values, but it doesn’t seem significant
Position feedback , setpoint value , changes ?
-position feedback only goes from -0.00012207 r to 0
-position feedback (raw) only from -1 to 0
