After MMos to Simcube getting an error

Simucube 1 Simucube 1 Questions
1

Good Morning

Before writing this post I reviewed the others that were in the community

The problem is that last Saturday I went from MMos to Simcube but it did not work for me.

The message that I receive is the following: could not connect to Ioni, reconnecting.

I’ve had a post that talked about updating the IONI firmware with the Granity application, as I have done with version 1.7.7

But when I start again, I still get the error

Could you help me solve the problem?

Thank you very much in advance

2

Unfortunately, there are only two things that could explain this:

  • You have Bus Address Offset in IONI (Granity) settings other than 0.
    or
  • you do not have a Simucube, and thus there is no way for the firmware to connect to IONI drive.

Can you describe the build you have? Is it pre-made or DIY?

3

Hello Mika

thanks for your quick response

It’s a pre-made system: SimRacingBay
Model: OSW IoniProHC & Ionicube 20nm 480w

4

Sorry attach do you have an screenshot

image
image744×715 23.4 KB

5

the second screenshot from Granity

image
image591×648 49.1 KB

6

IONICUBE based systems are not compatible with the Simucube firmware; you will have to manually put the system back to DFU mode using the dip switches, and flash MMOS firmware back.

7

If this is an Ionicube base system he will have to reflash the discovery board.

To do this you need to plug a USB cable into the other port on the discovery board.

I would suggest reaching out to the original builder. Be very careful not to knock any of the little wires off on the discovery board as their location is critical.

8

Ah, indeed, there are no dip switches on Discovery board, but a separate usb connector with integrated programming interface.

9

Mika you are lucky you missed those fun days! :slight_smile:

Trying to help someone troubleshoot the Ionicube1x board builds was much more challenging. Especially if it was a DIY build by someine with very little mechanical and electrical knowledge.

10

@Horacio_Garcia

Follow steps from here but don’t do the first step with the drc.

11

Hello

I working with your procedure and the OSW come back to life… :joy::joy::rofl::rofl:

I want to thank everyone for your help in solve my issue.

:clap::clap::clap::clap::clap::+1::+1::+1::+1:

2 Likes