SimuCUBE Open Source Firmware Development Update Thread 2

Simucube 1
178

I can test Today if you want

179

no need for extra testing anymore, just need to wait for Monday :slight_smile:

1 Like
180

Hi Mika, quick question about wiring button boxes into the X12 RJ45 sockets. I plan to purchase a 5m cat 5e cable and cut it in half to give me two bare wire ends and two RJ45 connector ends and wire this to my 14 buttons in the button box. I understand that the 7th button can function as a shift button giving me 32 button functions or so, so, does the shift button need to be a momentary or a latching switch, E.g for momentary I press button 7 and shift is activated and so whatever I press next is the second function or, for Latching, I can leave the switch in either primary or secondary function position.

Thanks in advance.

Stephen

181

You can use either type, but from the software side, it just looks if the shift is pressed and then shifts all the other buttons accordingly.

1 Like
182

Now that’s just a big tease!

1 Like
183

0.11.1 has been released just now.

6 Likes
184

Thx Mika. Unconing hardware features???:roll_eyes:

185

No hints as to what youre up to?

186

:sunglasses::shushing_face::zipper_mouth_face::beer:

the hint is in the smileys. But perhaps not these four smileys.

1 Like
187

Anybody having an issue with this update? If I watch the wheel it doesn’t turn immediately like it used to in the simucube software. Once I turn it about 30 degrees either way it keeps moving but if I stop it again I have to do the same thing again before it moves. It also doesn’t switch profiles all the time when you change them. It will change and then change back by itself.

188

Interesting. I noticed some lag in the UI for some reason, but the lag was not present in DIView or in control panel.

Do you see anything strange in the debug log?

189

No idea what you mean Mika

190

Debug log is available from the Advanced tab.

191

Lets continue bug reports / troubleshooting here:

1 Like
192

I will go there now.[quote=“Mika, post:191, topic:1540, full:true”]
Lets continue bug reports / troubleshooting here:


[/quote]

1 Like
193

Would “Initial firmware-level support for potential upcoming hardware feature is included in this build" influence any hardware purchase, as I’m considering changing servo. Thanks

1 Like
194

At the moment, there is 0.11.2 version already to be tested by @morpwr and a few others that noticed a cpu problem with that. Also, there is 0.11.3 in development. Busy times :wink:

2 Likes
195

Thanks Mika ill get on that tonight.

196

@morpwr tested and reported good news. Anyone else want to try?

197

Hello
Yes me tonight