Fanatec H-Shifter and Simucube

Hello !

It’s my first post, and excuse me for my english (I’m French :wink: )

Is it possible to connect and use the Fanatec H Shifter with the RJ connexion on the Simucube ?
I connected it on the back, but don’t see anything in the software.


My hardware configuration:
-MiGE 130ST-M10010
-IoniProHC 25A
-Firmware 0.8.12

From what I know, the Fanatec stuff uses SPI protocol to communicate, but I’m not sure about that.

You can not make them work directly by connecting to SimuCUBE, some development would have to be done to make it work.

See this thread:

1 Like

Hello Partaille,

Come in the french forum RFR-O :wink: