1.0.12 has some nice stuff for us 
https://granitedevices.com/wiki/Simucube_2_True_Drive_releases
1 Like
If there was a release date, we would put it on the website. It will be released when it is ready and tested.
1 Like
Looking forward to this release. Just read the notes and I think Mika must have been working 23 hours per day 
2 Likes
Documentation is now released here:
4 Likes
Yesss baby!!!
One less USB
4 Likes
handbrake and pedals on SC2 pro D-sub 15 pin
5 Likes
is it possible to connect a pressure transducer with 4 wires (5V, V-,V+,GND )directly to the D15 port?
Not at this point in time. But you can use a load-cell amp (similar to the ones Bodnar sell) to convert the output to an acceptable analog signal, which can be fed into the SC2 15-pin port …
Thanks Beano, i will look into use a load-cell amp to connect into the back of the SC2 or use a separate USB Load Cell board.
Cheers Mate, no dramas! Between Bodnar and DSD, you have good options with 16-bit controller-boards available.
i actually have the pressure transducer wired to a DSD 12bit controller currently but recently i am seeing lot of spiking in the brake pedal signal.
i have already tried bleeding the system few times and redo the connection with little improvements.
that is why i am looking to options to test if could be the sensor or the board or something else…
Hi all!
Just bought a shifter to connect directly to SC2 Accesory Port.
My question is, is it mandatory to use pin2-GND to one button and pin15-GNDto the other? Can I connect the 2 buttons to 1 GNDpin only?
Im Planning to connect the shifter right below my Handbrake and I want to use the same GND pin for Handbrake and 2 buttons
You can use the same GND pin.
1 Like
Nice job ! Is it possible to connect Fanatec SQ Shifter to D-SUB connector ? How to do ?
Dont know, but I think is not possible because the integrated control board.
My shifter was custom made without usb controller, buttons only are welded to connector
This is a YT video to connect fanatec handbrake to HE or other controller. I think it will be possible to do the same with Shifter SQ.
1 Like
Fanatec Handbrake looks straight forward to be conected to SC2 using analog inputs, but SQ shifter is a hall sensor IIRC that needs to translate position Into digital buttons
1 Like
so, it looks like there are hall effect sensors and related electronics in the shifter. Perhaps it is SPI, perhaps not, I wasn’t able to find out.