Hi, I updated my tuner software to 3.20 tonight. I then loaded LMU and for some reason my wheel began spinning and an error message appeared on the tuner software. Can’t remember exactly what it said but I cleared the message and loaded the game again. The game wasn’t recognising my wheel at this point, so I closed everything and rebooted my system but to no avail.
I decided to revert back to version 3.16 tuner software. No more errors or wheel spinning. All inputs work on my cube controls f1 pro wheel except my wheel doesn’t turn. The axis are inputted and it turns within the tuner software but not in game
Could you help please?
Have there been any other hardware changes in your system?
I was not able to repeat such behavior with the latest Tuner.
No further hardware changes
The wheel spinning pulled my usb cable from the connection on the wheel and continued to twitch. I’ve not experienced anything like it.
Like I say it was a direct result of the tuner software update
I have just tried configuring my wheel on AMS 2 and the wheel spun violently, ripped the USB cable out of the wheel and nearly broke my wrist because I was holding it!!
Just installed ACC and when I turned the wheel on set up it again spun violently but didn’t release the USB cable from wheel and nearly dragged my PC over, which cost me nearly 6K!!!
Something is going to get damaged and very expensive!!
Come on please what do I do???
Is the wheel also spinning in wrong direction if you enable desktop centering spring?
The FFB pipeline does not go through Tuner in any way, so it can’t be a Tuner update at fault. However there was a firmware update for Simucube 2 recently - but that didn’t have any FFB related changes either.
The wheel spun in the direction I turned it
Like I say I’ve had the wheelbase for 5 years and never had an issue until the latest tuner update. The issue started immediately
Also do you have any other suggestions?
Should I install the latest tuner version again?
Obviously at the moment I can’t use the wheel
Regards
Kev
The best way would be to make a support ticket at simucube.com - this is not our official support.
However, I would recalibrate the encoder.
I’ve submitted a ticket
I’ve submitted a ticket
How do recalibrate the encoder?