so i watched the video and everything went smoothly with the firmware install, or so it seemed. My config tool looks different and has errors.
This is what it looks like: https://i.imgur.com/rVypy1m.jpg
I don’t know how to go forward from here on.
did you manually update the IONI firmware to a supported version before you installed the firmware?
no, it was 11xxx so the min necessary as i understood from the wiki, and i thought thats was the update wizard does, or did.
We will get back to you, but unfortunately we are very busy yesterday and today. Keep an eye out for a private message on Saturday or Sunday.
wondering, my Granity is v1.10.1. and doesnt recognize it since the firmware update. Should i have updated it beforehand, or should i do it now anyway?
Update it anyway. Granity 1.14 is the latest, I think.
In the end, it turned out that the IONI firmware was too old. There were also some other parameters set in a strange way, which made the drive not to initialize.
My apologies to @Loft for not getting back to this issue sooner.
my fault for not being able to read numbers.