Simucube witi ioni pro - e stop pressed

hi, one of my ioni stating with e-stop pressed, u can see another ioni dont show the same, i can do some repar on ioni or jumper wiring in ioni for can do it work again?

u can see on video non listed here

Hi Rodrigo

Can you connect Granity to the IONI that states e-stop to be pressed?

Kind regards, Esa

in granity say

440205 Power stage forced off due to one or more of following reasons: over voltage, over temperature, over current, STO or short circuit active

maybe have another problem with ioni, and apears e-stop ?

Hi Rodrigo

I’m really sorry, I missed your reply completely!

This seems to be IONI issue, that the e-stop (STO) signal doesn’t work as it should.

You should however check the HV voltage from Granity/Testing tab just to rule out the other options. Please check all fault flags and readings, and preferable send a screen capture of those.

Once again, I’m sorry for this way-too-late reply.

Kind regards, Esa