Hello,
i can put any value, but it don’t work.
Set it to hard and try it
No, it don’t work…
Which firmware version is this?
I will try to repeat the issue.
when adjusting bumpstops, the current implementation waits for wheel returning to within the range before enabling the effect.
No, nothing.
But now i starting the complete setup again
No, the same problem. Bump stop don’t exist.
I will take a look at this later this week.
Thank you very much…
Are i am alone with that Problem? Maybe, i can install all from scratch.
I resolved it, restart the simucube by turning off.
Funny. If this happens again, please tell me how to repeat it; I could not make it happen.