Unfortunately I have my first big problem with the Simucube 1. After switching on, the message "Motor Faults: Intialization Fault! "In the control box the IONI flashes alternately green and orange. What can I do?
Version is 1.0.23
IONI drive firmware Version 10716
If I start with E-Stop pressed and then open it, this appears:
Fault Location ID: 440205 Power stage forced off due to one or more of following reasons: over voltage, over temperature, over current, STO or short circuit active
can you enter granity and show the settings from all the tabs ? maybe something is messed up.
I have reloaded the motor file and now it works again!
