Help Granity configuration

Hi everyone, I have a friend who has a problem with granity. He bought an Augury kit and had never hooked up to granity. He updated the encoder and wanted to enter the parameters to make it work. After you have enabled the usb from the new firmware, going granity does not appear simplemotion but only COM2 and TPC. What to do to solve it?

You might need to install FTDI:s drivers for the virtual com port for it to appear.

http://www.ftdichip.com/Drivers/VCP.htm

Thank you Mika, I hope I can solve it

Hi, I’m in the same problem. I have upgrade to Simucube firmware, and now I can’t access to Granite software.

Can’t connect at all, even if you enable the usb connection as required?

Solved. I have reinstalled FTDI drivers and now everything it’s ok.

Thanks,