I finally got my wheel to work, (small mige, Biss encoder). I can only get Granity and the Configuration tool to connect independently by switching the dfu switched on the circuit board. Is this correct?
Kind Regards
Stu
you need to click the “Enable IONI Configuration Mode” in Simucube to enable the USB sport to speak to Granity.
As easy as that, thank you for the prompt reply. Is it beneficial to have them both available or just enable for granity when needed?
It is either-or. Only the Simucube firmware OR the USB port (Granity) can talk to IONI drive, both can’t talk at the same time.