Hey Guys,
I’ve recently spilt water on my Simucube 1 which of course has caused damage, I’ve purchased a replacement FFB Controller Board and reassembled but the desktop FW config tool doesn’t connect to the wheel. I can connect using the Granity software as normal, I’ve taken some snippets of device manager & FW tool… any help would be welcome
The boards ship with no firmware installed - you must install the Simucube Bootloader dfu file from the latest package by using the DfuSeDemo software. Then install Simucube Firmware version 0.11.2. Installing 0.50.4 will not work, but after you’ve set up the system with 0.11.2 so that you can drive, you can update back to 0.50.4.
