Elecrically, a potentiometer looks like this (note that SimuCUBE uses 3.3V, but this can be ignored if you just follow the wiring example and connect to the 3.3V pin).
and a button can be wired between the X12 pin 8 and any other pin on X12.
Do you think I can use this sensor with 3.3V?
How can I use it?
So for the accelerator I am going to use a potentiometer I will not have problems when connecting it with 3.3V. Will it work just like if I use another type of electronic board?
Please see the connector pinouts. Buttons should be connected to X12 and potentiometers to X11 upper connector if you want them to work with MMOS firmware.
Did you manage to install MMOS firmware? We don’t offer official support for using it.
How is it possible that at first they worked and then no longer work?
The PC if it detects the plate but the buttons and potentiometers do not work, it does nothing.
I only have one problem, without touching buttons, without touching potentiometers, without touching anything.
The number 30 is in red as active or pulsed.
Because it can be?
I configured MMos
I have connected potentiometers X11 upper
It works very well.
Pin 1 brake - rotation X
Pin 2 accelerator-rotation Y
Pin 4 clutch - rotation z
When moving the axis of the motor Migue 130ST moves the AXIS X
I want to connect a further potentiometer to pin 3 or pin 5 of the X11 connector upper, but it does not work.
Do you have to configure something?
A greeting.
I want to connect a further potentiometer to pin 3 or pin 5 of the X11 connector upper, but it does not work.
Do you have to configure something?
A greeting