Need help. I have a two pedal set break is hydraulic gas has potentiometer and the board being used is leo bodner bu0836 i want to connect straight to simucube 2 pro and use true drive software what do I need to do to make this happen. Thx
You probably will not be able to connect directly due to the hydraulic Brake pedal as it is probably using the BU0836 load cell (if it is that vision) to amplify what is probably a pressure sensor on the Brake… However if it is NOT an LC version you ghould be able to connect the Power Ground and Signal wires Separate from the BU board to the simucubes DB25 port in the correct locations and go through the SC2 direct.