Buttons with build in light

When I ad push buttons with a build in light to my simcube rj45 plug wil the simcube output 3-5 volts from pin 1-7 rj45? (Pin 8 is ground )
Wiki talks only About wich connector en pins but not of there is a output current

Buttons are pulled up on the SimuCUBE to 3.3 V through a 3.3 kOhm pull-up resistor. I would guess, that the resistor would limit the output current so low ( <1 mA) that even a simple led would not light up.

Hello again, I can confirm that the build in lights
In the switch are working trough the simcube!