Argon Fault Output

Questions Motor drives
1

Hi there,

I have a question regarding Argon fault output GP03.

My hardware configuration:
-Argon drive
-3ph AC servo motor
-Firmware v2.1.2

How I would expect Argon fault output behave in safety manner way. When the drive runs fine the GP03 output should conduct, and when there is a problem the GP03 not conduct. This manner will also handle incident of power failure and wire broken automatically.

I looked into Granity software for configuring fault output, expected to be same as GDTool. But there is none or may be miss out something.

Thanks
Weerasak